Front Door Panel: Service and Repair

Front Door Panel Removal/Installation

Special Tools Required
- KTC trim tool set SOJATP2014 *
- Trim pad remover. Snap-on A 177A or equivalent, commercially available
* Available through the American Honda Tool and Equipment Program

NOTE: Use the appropriate tool from the KTC trim tool set to avoid damage when removing components.

1. Lower the glass fully.




2. Remove the inner handle (A). Take care not to scratch the door panel.
1. Remove the screw.
2. Pull the inner handle forward and out half-way to release the hooks (B).
3. Disconnect the inner handle rod (C).




3. Remove the grip cover (A).
1. Using the appropriate trim tool, pry out the front bottom edge of the cover while pushing up the clips (B).
2. Release the hooks (C, D) from the power window switch panel (E).
3. From front to rear, pry out along the edge of the cover to release the hooks (F, G).
4. Release the rear hook (H), while pulling the cover forward.




4. Disconnect the power window switch connectors (A, B). Remove the screws from the grip base (C).




5. Release the clips that hold the door panel (A), then release the lock knob rod (B) from the hole in the door panel, and remove the door panel by pulling it upward. Remove the door panel with as little bending as possible to avoid creasing or breaking it.




6. For some models: Disconnect the tweeter connector (A).
7. Install the door panel in the reverse order of removal, and note these items:
- Check for damaged or stress-whitened clips, and if necessary, replace them with new ones.
- Make sure the connectors are plugged in properly, and the rod is connected securely.
- Push the clips into place securely.
- When reinstalling the door panel, make sure the plastic cover is installed properly and sealed around its outside perimeter to seal out water.