Front Seat Cushion Cover/Pad Replacement

Front Seat Cushion Cover/Pad Replacement

Special Tools Required

KTC trim tool set SOJATP2014 *
* Available through the American Honda Tool and Equipment Program

SRS components are located in this area. Review the SRS component locations and the precautions and procedures before doing repairs or service.

- Check the operation of the driver's seat position sensor after any of these actions:
- Driver's seat position sensor replacement
- Cover plate (front side of driver's seat slide rail) replacement

- Calibrate the ODS unit after any of these actions;
- Front passenger's seat replacement (including any seat components)
- Replacement of the seat weight sensors
- After a vehicle collision

NOTE:
- Use the appropriate tool from the KTC trim tool set to avoid damage when prying components.
- Take care not to tear the seams or damage the seat covers.
- Put on gloves to protect your hands.

1. Remove the front seat:
- Driver's seat.
- Passenger's seat.

2. Separate the seat-back and the seat cushion.




3. Release the hooks (A) from both sides of the seat cushion.




4. Release the seat cushion cover (A) from the
- cushion frame spring (B), and release the hooks (C) from under the seat cushion.




5. Remove the seat cushion cover/pad (A) from the seat cushion frame (B).
6. Install the seat cushion cover/pad in the reverse order of removal. To prevent wrinkles when installing a seat cushion cover, make sure the material is stretched evenly over the pad before securing the hooks.