Rear Seat Control Cable Replacement

Rear Seat Control Cable Replacement

NOTE:
- Put on gloves to protect your hands.
- Take care not to kink the cable.
- Take care not to tear the seams or damage the seat covers.
- The left seat-back is shown; the right seat-back is similar.

1. Remove the rear seat assembly.
2. Remove the seat cushion.
3. Remove the seat cushion cover/pad and the silencer.




4. Remove the wire tie (A). Disconnect the control cable (B), then remove the cable.

5. Install the cable in the reverse order of removal, and note these items:
- Replace the wire tie you removed with a new one.
- Make sure the control cable is routed properly and connected securely.
- Fix at the original position in the end of the cable on the cable bracket securely. And check the rear seat tip-up operation:
- Make sure the rear seat cushion unlocks by lifting the leg. If necessary, adjust the position of the cable end.