Countershaft Bearing Replacement

Countershaft Bearing Replacement

Special Tools Required
^ Adjustable bearing puller, 25 - 40 mm 07736-A01000B
^ Attachment, 52 x 55 mm 07746-0010400
^ Driver 07749-0010000
^ Slide hammer, 3/8"-16 commercially available

1. Remove the needle bearing (A) using the 25 - 40 mm adjustable bearing puller (B) and commercially available 3/8"-16 slide hammer (D), then remove the oil guide plate C.





2. Position the oil guide plate C and new needle bearing (A) in the bore of the clutch housing (B).





3. Install the needle bearing using the driver (D) and 52 x 55 mm attachment (E).