Front Door Panel: Service and Repair

Door Panel Removal/Installation

Special Tools Required
- KTC trim tool set SOJATP2014 *
- Trim pad remover. Snap-on A 177A or equivalent, commercially available
* Available through the American Honda Tool and Equipment Program.

NOTE:
- Take care not to scratch the door panel and door.
- Use the appropriate tool from the KTC trim tool set to avoid damage when prying components.

1. Remove the door panel in the numbered sequence. Remove the door panel with as little bending as possible to avoid creasing or breaking it.
2. Install the panel in the reverse order of removal, and note these items:
- Check if the clips are damaged or stress-whitened, and if necessary, replace them with new ones.
- Make sure the connectors are plugged in properly.
- Push the clips into place securely.
- Check the window and power door lock operations.
- When reinstalling the door panel, make sure the plastic cover is installed properly and sealed around its outside perimeter to seal out water.
- Check for water leaks.