Rear Brake Caliper Removal/Installation
Rear Brake Caliper Removal/InstallationCAUTION:
Frequent inhalation of brake pad dust, regardless of material composition, could be hazardous to your health.
^ Avoid breathing dust particles. Never use an air hose or brush to clean brake assemblies. Use an OSHA-approved vacuum cleaner.
^ Thoroughly clean the outside of the caliper to prevent dust and dirt from entering inside.
1. Raise the rear of the vehicle, and support it with safety stands in the proper locations.
2. Remove the rear wheel.
3. Release the parking brake.
4. Remove the caliper shield (A).
5. Remove the brake hose mounting bracket (A) from the rear caliper body.
6. Remove the cable clip (A) from the parking brake cable (B)
7. Disconnect the parking brake cable end from the parking brake arm (C).
8. Remove the banjo bolt (A), and disconnect the brake hose (B) Remove the two sealing washers (C), and replace them. Do not spill brake fluid on the vehicle; it may damage the paint; if brake fluid gets on the paint, wash it off immediately with water.
9. Remove the flange bolt (D) while holding the caliper pin (E) with a wrench and being careful not to damage the pin boot, and remove the caliper (F) from the bracket.
10. Install the rear brake caliper in the reverse order of removal, and note these items:
^ When installing the caliper, align the cutout in the piston with the tab on the inner pad.
^ Check the brake hose and caliper fitting for leaks, and tighten the banjo bolt if necessary.
^ Check the brake hoses for interference and twisting.
^ Contaminated brake discs or pads reduce stopping ability. Keep paste off of the discs and pads.