Steering Column: Service and Repair

Steering Column Removal and Installation
SRS components are located in this area. Review the SRS component location, and precaution, and procedures before doing repairs or service.

Removal
1. Make sure you have the anti-theft code for the audio, then write down the audio preset, and disconnect the negative battery cable from the battery.
2. Remove the driver's airbag assembly, steering wheel, and the cable reel.
3. Remove the column covers (A).





4. Remove the combination switch assembly (B) from the steering column shaft by disconnecting the connectors and removing the screws.
5. Disconnect the ignition switch connectors from the under-dash fuse/relay box.
6. Remove the steering joint bolt (C).
7. Remove the steering column (D) by removing the attaching nuts (E) and bolts (F).

Installation
1. Install the steering column, and make sure the wires are not caught or pinched by any parts.
2. Insert the lower end of the steering joint (A) onto the steering shaft (B) (line up the bolt hole (C) with the flat portion (D) on the shaft).





3. Pull on the steering joint to make sure that the steering joint is fully seated, but do not pull excessively on the joint. Then install the steering joint bolt (E) and tighten it to the specified torque.

'00 model:
U.S.A. models VIN JHMAP 114-YT000001 thru VIN JHMAP 114-YT008411
Canada models VIN JHMAP 114-YT800001 thru VIN JHMAP 114-YT800750
Torque: 22 Nm (2.2 kgf-m, 16 lbf-ft)

Other models:
Torque: 29 Nm (3.0 kgf-m, 22 lbf-ft)

4. Finish the installation, and note these items:

^ Make sure the wire harness is routed and fastened properly.
^ Make sure the connectors are properly connected.
^ Reinstall the steering wheel.
^ Reconnect the negative battery cable to the battery.
- Enter the anti-theft code for the audio, then enter the audio presets.
- For '01-08 models; set the clock.
- For '00-05 models; do the ECM idle learn procedure.
^ Verify cruise control, horn, and turn signal switch operation.
^ Check wheel alignment.