Differential Case Assembly Removal and Installation
Differential Case Assembly Removal and Installation1. Remove the output shafts (A) from the differential using the pry bars (B).
2. Remove the ten mounting bolts in a crisscross pattern in several steps, then remove the differential case.
3. Clean the dirt and oil from the mating surfaces. Apply liquid gasket, P/N 08718-0001 evenly to the mating surface of the differential case and the differential carrier. Install the component within 5 minutes of applying the liquid gasket.
4. Install the differential case.
5. Tighten the ten mounting bolts in a crisscross pattern in several steps.
6. Install the new clips (A) on the output shafts, then install the output shafts (B).
