Rear Side Area

Interior Trim Removal/Installation - Rear Side Area

Special Tools Required
- KTC trim tool set SOJATP2014*

2-door

SRS components are located in this area. Review the SRS component locations SRS Component Location Index (2-Door) and the precautions and procedures Technician Safety Information before doing repairs or service.

NOTE:

- Put on gloves to protect your hands.

- Take care not to bend or scratch the trim and the panels.

- Use the appropriate tool from the KTC trim tool set to avoid damage when removing components.

1. Remove these items:
- Door sill trim Interior Trim Removal/Installation - Door Sill Area (2-Door)

- C-pillar trim 2-Door

- Rear seat-back Rear Seat Removal/Installation

- Rear seat cushion Rear Seat Removal/Installation

2. Lower the rear seat pivot bracket (A).






3. Remove the rear side trim panel (A).
-1 Remove the clip (B).
-2 Gently pull the rear shelf (C) back to release the projections (D) and detach the hook (E) from the panel.
-3 Detach the clips (F) by pulling the panel back.
-4 Release the hooks (G) and the tabs (H) from the B-pillar upper trim (I).

4. Install the panel in the reverse order of removal, and note these items:
- If the clips are damaged or stress-whitened, replace them with new ones.

- Push the clips and the hooks into place securely.