Drivers Power Seat Motor Test (With Power Seat)

Driver's Power Seat Motor Test

1. Remove the driver's seat. Front Seat Removal/Installation

2. Remove the power seat adjustment switch knobs and the recline cover from the seat. Front Seat-Back Cover Replacement (4-Door)

3. Disconnect the 12P connector (A) from the power seat adjustment switch (B).






4. At the 12P connector of the driver's seat wire harness side, test the motor by applying battery power and ground to the terminals according to the table.

5. If the motor does not run or fails to run smoothly, go to step 6.

Slide motor





Recline motor





Front up-down motor





Rear up-down motor





6. Disconnect the 2P connector from each motor.
NOTE:

- For the recline motor, remove the seat-back cover, 2-door Front Seat-Back Cover Replacement (2-Door), 4-door. Front Seat-Back Cover Replacement (4-Door)

- All connector views are wire side of female terminals.

7. Check for continuity between each motor 2P connector and the driver's seat wire harness 12P connector. If there is continuity, replace the appropriate motor:
- Slide motor Front Seat Slide Motor Replacement (4-Door)

- Recline motor Front Seat Recline Motor Replacement

NOTE: The front and rear up-down motors are part of the up-down adjuster.