Rear Seat Armrest Replacement (4-Door)

Rear Seat Armrest Replacement

Special Tools Required
- KTC trim tool set SOJATP2014*

4-door

NOTE:

- Use the appropriate tool from the KTC trim tool set to avoid damage when removing components.

- Take care not to tear the seams of damage the seat covers.

1. Fold the seat-back down.

2. Remove the trunk pass-through lid. Trunk Pass-Through Lid Replacement (4-Door)

3. Release the hook strip (A), then turn over the seat-back cover (B) as necessary.






4. Remove the clip (A) from the left portion of the armrest pivot (B).






5. Remove the armrest clip (B) from the slit in the collar A by pinching the clip.






6. Slide the armrest (A) toward the driver's side of the vehicle, and remove the pivot shaft (B) from the collar (C) on the right side of the vehicle by pulling back on the armrest.






7. Remove the pivot shaft (A) from the collar (B) on the left, then remove the armrest (C).






8. Remove the collars (A) from the seat-back (B).

9. Install the armrest in the reverse order of removal, and prevent wrinkles when installing a seat-back cover, make sure the material is stretched evenly over the pad before securing the hook strips.