A/T Differential Carrier Bearing Side Clearance Inspection (A/T)

A/T Differential Carrier Bearing Side Clearance Inspection

Special Tools Required

- Driver handle, 40 mm I.D. 07746-0030100
- Attachment, 30 mm I.D. 07746-0030300

1. Install the spacer (A) in the torque converter housing with the spacer tab (B) into the guide. Do not install the spacers mix-up in the transmission housing and the torque converter housing.

2. Install the differential assembly (C) in the torque converter housing, and put the spacer (D) on the differential.






3. Install the differential assembly securely using the 40 mm I.D. driver handle and the 30 mm I.D. attachment in the torque converter housing, so there is no clearance between the bearing, the spacer, and the torque converter housing.






4. Install the 90 mm thrust shim (A) in the transmission housing (B).
If you replace the 90 mm thrust shim with a new one, use the same thickness as the old one.






5. Align the spring pin (A) on the selector control shaft (B) with the transmission housing groove (C) by turning the control shaft with the detent plate (D).
NOTE: Do not squeeze the end of the selector control shaft tips together when turning the control shaft.

6. Install the gasket (E) and the three dowel pins (F) on the torque converter housing (G).

7. Place the transmission housing (H), and install the mounting bolts (19 bolts). Tighten the bolts to the specified torque in a crisscross pattern in at least two steps.






8. Measure the clearance between the 90 mm thrust shim and the spacer using a feeler gauge.





9. If the clearance is out of standard, remove the 90 mm thrust shim, and measure its thickness.

10. Select and install a new thrust shim. Recheck the clearance and make sure it is within the standard.

THRUST SHIM, 90 mm