Countershaft Reverse Selector Hub Removal (A/T)

Countershaft Reverse Selector Hub Removal

1. Remove the reverse selector hub from the countershaft by hand. If the reverse selector hub (A) cannot be removed by hand, it is press-fitted to the countershaft (B), and remove it from the countershaft with a press. Place 4th-5th gear (C) on press bases (D), and place a spacer (E) between the countershaft and the press to prevent damaging the countershaft.
NOTE: Some reverse selector hubs are not press-fitted, and can be removed without using a press.

2. Support the bottom of the countershaft with one hand, then press the countershaft out of the press-fitted reverse selector hub, and remove the countershaft while holding the underside the countershaft. The countershaft will drop down after pressing it out of the press-fitted reverse selector hub.

3. Remove the remaining parts from the countershaft, if necessary.