Dashboard Vent Removal/Installation

Dashboard Vent Removal/Installation

Special Tools Required

- KTC trim tool set SOJATP2014*

Driver's Outer Vent

NOTE:

- Take care not to scratch the dashboard and related parts.

- Use the appropriate tool from the KTC trim tool set to avoid damage when removing components.

1. Remove the subdisplay visor. Subdisplay Visor Removal/Installation

2. Remove the screws securing the driver's outer vent (A), then remove the driver's outer vent from the subdisplay visor (B).

3. Install the outer vent in the reverse order of removal.






Driver's Center Vent

NOTE: Take care not to scratch the dashboard and related parts.

1. Remove these items:
- Navigation unit, with navigation system:
- '09 model Service and Repair

- Audio unit, without navigation system:
- '09 model Audio Unit Removal/Installation (Without Navigation, With Audio)

2. Remove the screws securing the driver's center vent (A), then remove the driver's center vent from the center panel (B).

3. Install the center vent in the reverse order of removal.






Passenger's Vent

SRS components are located in this area. Review the SRS component locations, 2-door, SRS Component Location Index (2-Door) 4-door SRS Component Location Index (4-Door) and the precautions and procedures Technician Safety Information before doing repairs or service.

NOTE:

- Take care not to scratch the dashboard and related parts.

- Use the appropriate tool from the KTC trim tool set to avoid damage when removing components.

- Put on gloves to protect your hands.

1. While holding the glove box (A), release the glove box stops (B) on each side from the dashboard by pushing them in.






2. From inside the glove box opening, push on the side hooks (A) by hand to release them. Gently pull out the side vent (B) to release the other hooks (C), then remove the passenger's vent.

3. Install the passenger's vents in the reverse order of removal.

Outer





Center