Removable Hardtop Roof Molding Replacement

Removable Hardtop Roof Molding Replacement

NOTE:

- Put on gloves to protect your hands.

- Remove the hardtop from the body before removing or installing the headliner.

- Take care not to scratch the hardtop.

- Use a clip remover to remove the clip.

- If you are reinstalling the old retainer, scribe a line around each mounting screw before removing the retainer.

Removal

Remove the B-pillar trim, Removable Hardtop Interior Trim Removal/Installation then remove the roof molding as shown.






Installation

Install the roof molding in the numbered sequence, and note these items:

- Before reinstalling the roof molding, use isopropyl alcohol to clean the roof surface where the sealant will be applied.

- When reinstalling the roof retainer, align it with the marks made during removal.

- Check that the weatherstrip is securely installed to the retainer.

- Check that the door glass contacts the weatherstrip evenly. If necessary, adjust the retainer.

- Check for water leaks. Adjustments





Weatherstrip Check

NOTE:

- Make sure the hardtop is locked securely with both lock handles and both roof side locks.

- Check that the weatherstrip is securely installed to the retainer.

- Raise the glass fully.

- Check that the door glass contacts the weatherstrip evenly.

- Check for water leaks. Adjustments

- Test-drive, and check for wind noise.