Imoes Unit Input Test/Replacement

Imoes Unit Input Test/Replacement

'08-09 models

1. Remove the blower motor. Blower/Evaporator Unit Component Replacement (With A/C)

2. Remove the bolt (A) from the imoes unit bracket (B).

3. Remove the imoes unit (C) from the imoes unit bracket.

4. Disconnect the 5P connector (D) from the imoes unit.

5. Inspect the connector and socket terminals to be sure they are all making good contact.
- If the terminals are bent, loose or corroded, repair them as necessary and recheck the system.

- If the terminals look OK, go to step 3.

6. With the connectors still disconnected, do these input tests at the following connectors.
- If any test indicates a problem, find and correct the cause, then recheck the system.

- If all the input tests prove OK, replace the imoes unit, then do the imoes unit registration with the HDS, and make sure the immobilizer indicator blinks correctly.