Rear Stabilizer Bar Replacement

Rear Stabilizer Bar Replacement

1. Raise the rear of the vehicle, and support it with safety stands in the proper locations. Service and Repair

2. Remove the rear wheels.

3. Remove the self-locking nut (A) while holding the joint pin (B) with a hex wrench (C), and disconnect both stabilizer links (D) from the stabilizer bar (E).
NOTE: Use a new self-locking nut during reassembly.






4. Remove the bolts (A) and bushing holders (B), then remove the bushings (C) and the stabilizer bar (D).

5. Install the stabilizer bar in the reverse order of removal, and note these items:
- Refer to stabilizer link removal/installation to connect the stabilizer bar to the links. Rear Stabilizer Link Removal/Installation

- Before installing the wheel, clean the mating surfaces of the brake disc and inside of the wheel.