Pulley End Crankshaft Oil Seal Installation - In Car (R18A1 and R18A4 Engine)

Pulley End Crankshaft Oil Seal Installation - In Car

Special Tools Required

- Oil seal driver 07LAD-PT3010A
1. Remove the crankshaft pulley. Service and Repair

2. Remove the pulley end crankshaft oil seal.

3. Clean and dry the crankshaft oil seal housing.

4. Apply a light coat of new engine oil to the crankshaft and to the lip of the crankshaft oil seal.

5. Using the oil seal driver, drive in the new crankshaft oil seal until the oil seal driver bottoms against the oil pump. When the seal is in place, clean any excess grease off the crankshaft, and check that the oil seal lip is not distorted.

6. Install the crankshaft pulley. Service and Repair