Oil Separator: Service and Repair

Engine Oil/Air Separator Installation

1. Remove all of the old liquid gasket from the oil/air separator mating surfaces, the bolts, and the bolt holes.

2. Clean and dry the oil/air separator mating surfaces.

3. Apply liquid gasket, P/N 08717-0004, 08718-0003, or 08718-0009 to the engine block mating surface of the oil/air separator, and to the inside edge of the threaded bolt holes. Install the component within 5 minutes of applying the liquid gasket.
NOTE:

- Apply a 3 mm (0.12 in) diameter bead of liquid gasket along the broken line (A).

- If too much time has passed after applying the liquid gasket, remove the old liquid gasket and residue, then reapply new liquid gasket.





4. Install the oil/air separator.
NOTE:

- Wait at least 30 minutes before filling the engine with oil.

- Do not run the engine within 3 hours after installing the oil/air separator.