Removal and Replacement

Power Steering Pump Replacement

1. Place a suitable container under the vehicle to catch any spilled fluid.

2. Drain the power steering fluid from the reservoir. Service and Repair

3. Remove the cowl cover and under-cowl panel. Service and Repair

4. Remove the air cleaner. Service and Repair

5. Remove the front splash shield, 2-door, Front Splash Shield Replacement 4-door. Front Splash Shield Replacement

6. M/T: Remove the shift cable bracket (A).

7. A/T: Disconnect the shift cable from the control lever. Service and Repair






8. Remove the upper torque rod mounting bolts (A) from the body.
NOTE: During installation, install new mounting bolts.






9. Remove the drive belt (A) from the pump pulley. Service and Repair

10. Cover the parts around the power steering pump with several shop towels to protect them from spilled power steering fluid.

11. Disconnect the pump inlet hose (B) and the pump outlet hose (C) from the pump (D), and plug them. Take care not to spill the fluid on the body or any parts. Wipe off any spilled fluid at once. Do not turn the steering wheel with the pump removed.

12. Remove the pump outlet hose O-ring (E).

13. Remove the pump mounting bolts (F).

14. Cover the opening of the pump with a piece of tape to prevent foreign material from entering the pump.






15. Move the power steering pump toward the driver's side, then remove it.

16. Connect the pump inlet hose and the pump outlet hose onto the new pump with a new O-ring.

17. Loosely install the pump in the pump bracket with the mounting bolts, then tighten the pump fittings securely.

18. Tighten the pump mounting bolts to the specified torque.






19. Install the drive belt (A). Service and Repair
Note these items during belt installation:

- Inspect the belt for wear and cracks. Replace the belt if necessary.

- Make sure that the belt is properly positioned on the pulleys (B).

- Do not get power steering fluid or grease on any parts around the power steering pump, and drive belt, or pulley faces. Clean off any fluid or grease before installation.

20. Reinstall all removed parts.

21. Fill the reservoir to the upper level line. Service and Repair

22. Start the engine, and check for leaks.