A/T Housing Bearing Installation

A/T Housing Bearing Installation

Special Tools Required

- Attachment, 72 x 75 mm 07746-0010600
- Attachment, 78 x 80 mm 07NAD-PX40100
- Attachment, 62 x 68 mm 07746-0010500
- Driver handle, 15 x 135L 07749-0010000
1. Install the mainshaft bearing (A), the countershaft bearing (B), the secondary shaft bearing (C), and the idler gear shaft bearing (D) in the transmission housing in the direction shown.

2. Expand each snap ring using snap ring pliers, and install the bearing part-way into the housing.

3. Release the pliers, then push the bearing down into the housing using the driver handle and the attachment until the snap ring snaps in place around it.






4. After installing the bearings check that the snap rings (A) are seated in the bearing and housing grooves, and that the ring end gaps (B) are 0-7 mm (0-0.28 in).






5. Install the idler gear shaft (A) in the idler gear shaft bearing.

6. Install the cotters (B) and the cotter retainer (C), and secure the idler gear shaft with the snap ring (D).