ATF Warmer Replacement

ATF Warmer Replacement

1. Remove the splash shield.

2. Drain the engine coolant. Service and Repair

3. Do the battery removal procedure. Removal and Replacement

4. Remove the air cleaner assembly Service and Repair and the intake air duct.

5. Remove the battery tray, the battery base, and the resonator.

6. Disconnect the water by-pass hoses (A) and the ATF warmer hoses (B) from the ATF warmer (C), and turn the hose ends up to prevent fluid from flowing out.

7. Remove the ATF warmer, and replace it with new one.

8. Install a new ATF warmer on its bracket (D).

9. Slide the water by-pass hoses to the ATF warmer, and secure the hoses with the clips.

10. Slide the ATF warmer hoses over the ATF warmer lines (E) until the hose ends contact the bulge (F), and secure the hoses with the clip (G) at 2-4 mm (0.08-0.16 in) (H) from the hose end.

11. Install the battery base, the battery tray, and the resonator.

12. Install the intake air duct and the air cleaner assembly. Service and Repair

13. Do the battery installation procedure. Removal and Replacement

14. Install the splash shield.

15. Check the ATF level, and add ATF to the proper level if necessary. Procedures

16. Fill the engine cooling system with recommended coolant. Service and Repair

17. Start the engine in P or N, and warm it up to normal operating temperature (the radiator fan comes on).Turn off the engine, and recheck the ATF level. Procedures