61-2x

SRS DTC Troubleshooting: 61-2x

DTC 61-2x ("x" can be 0 thru 9 or A thru F):

Short in the Driver's Seat Belt Buckle Switch

NOTE: Before doing this troubleshooting procedure, review SRS Precautions and Procedures Service and Repair and General Troubleshooting Information Reading and Clearing Diagnostic Trouble Codes.

1. Clear the DTCs with the HDS Reading and Clearing Diagnostic Trouble Codes.

2. Turn the ignition switch to LOCK (0), then wait for 10 seconds.

3. Turn the ignition switch to ON (II), then buckle and unbuckle the driver's seat belt several times.

4. Check for the DTCs with the HDS Reading and Clearing Diagnostic Trouble Codes.

Is DTC 61-2x indicated?

YES -

Go to step 5.

NO -

Intermittent failure, the system is OK at this time. Go to Troubleshooting Intermittent Failures Reading and Clearing Diagnostic Trouble Codes. If another DTC is indicated, troubleshoot the DTC.�

5. Turn the ignition switch to LOCK (0).

6. Disconnect the floor wire harness 2P connector (A) from the driver's seat belt buckle switch.






7. Clear the DTCs with the HDS unit.

8. Turn the ignition switch to ON (II), then wait for 10 seconds.

9. Check for the DTCs with the HDS.

Is DTC 61-2x indicated?

YES -

Short to ground in the floor wire harness; replace the floor wire harness then clear the DTC.�

NO -

Faulty driver's seat belt buckle switch; replace the driver's seat belt buckle assembly Front Seat Belt Replacement, then clear the DTC.�