Rear Seat-Back Cover Replacement (2-door)

Rear Seat-Back Cover Replacement

2-door

NOTE:

- Put on gloves to protect your hands.
- Take care not to tear or damage the seat covers.

1. Remove the seat-back Rear Seat Removal/Installation.

2. Remove all of the head restraints.

3. Remove the screw, then remove the center seat belt guide (A).






4. Release the lower hook strips (A) and the side hook strips (B).






5. Turn over the seat-back cover (A), then release the hook strips (B).






6. Pull out the seat-back frame (A) from the seat-back cover/pad (B), then remove the head restraint guides (C) and the center head restraint guides (D) while pinching the end of the guides.





7. Remove the seat-back cover/pad from the seat-back frame.

8. Remove the seat-back cover (A).

1. Pull back the edge of the seat-back cover all the way around.

2. Remove the upholstery rings (B).

3. Release the hooks (C) of the lateral wires (D) from the longitudinal wires (E) on the pad.

NOTE: The seat-back cover except the leather seat-back cover is shown; the leather seat-back cover is similar.





9. Install the seat-back cover in the reverse order of removal, and note these items:

- To prevent wrinkles when installing the seat-back cover, make sure the material is stretched evenly over the pad before securing the upholstery rings and the hook strips.
- Replace all of the upholstery rings (A) fastening the seat-back cover (B) to the pad wires (C) with new ones using commercially available upholstery ring pliers (D).