Manufacturer Code Charts: 1302

Navigation System DTC Troubleshooting: 1302

DTC 1302:

GPS Receiver Error 1

NOTE:

- Check the vehicle battery condition first Battery Test.
- This navigation DTC sets when there is an internal GPS receiver problem.
- Before you troubleshoot, make sure to follow the General Troubleshooting Information Reading and Clearing Diagnostic Trouble Codes.
- Make sure the vehicle is parked outside, away from buildings.
- Aftermarket electronic devices located near the navigation unit or GPS antenna can potentially interfere with the operation of the navigation system.

1. Clear the hard error code.

2. Turn the ignition switch to LOCK (0) and then back to ON (II).

3. Check for the hard error code.

Is DTC 1302 indicated?

YES -

Go to step 4.

NO -

Intermittent failure, the system is OK at this time.

4. Check for the hard error code.

Is DTC 1301 indicated?

YES -

Do the DTC 1301 troubleshooting 1301.

NO -

Intermittent failure, the system is OK at this time. If the vehicle repeatedly comes back with the navigation DTC, replace the navigation unit Service and Repair.