Audio Unit Removal/Installation (Without Navigation)

Audio Unit Removal/Installation

Without Navigation

SRS components are located in this area. Review the SRS component locations SRS Component Location Index (2-Door), and the precautions and procedures Service and Repair before doing repairs or service.

NOTE:

- Put on gloves to protect your hands.
- Take care not to scratch the dashboard and related parts.
- Lay a shop towel under the parts when working on them to protect the face panel from scratches or other damage.
- Eject all the discs before remove the audio unit to prevent damaging the CD player's load mechanism.
- If you are replacing the audio unit, write down the audio presets (if possible), then enter them into the new audio unit.

1. Make sure you have anti-theft code for the audio system.

2. Remove the center console panel Center Console Panel Removal/Installation and the center pocket Dashboard Center Pocket Removal/Installation (Without Navigation).

3. Remove the driver's inner dashboard trim Driver's Inner Dashboard Trim Removal/Installation, and the passenger's dashboard trim Passenger's Dashboard Trim Removal/Installation.

4. Remove the self-tapping screws and bolts (A), then pull out the audio unit (B).





5. Disconnect the connectors (C), then remove the audio unit.

6. Remove the climate control unit or the HVAC control unit HVAC Control Unit Removal/Installation.

7. Remove the mounting screws and bolts (A) from the audio unit (B), then remove the audio unit from the center panel (C).





8. Install the audio unit in the reverse order of removal, and note these items:

- Make sure all the connectors and the antenna lead are secure.
- Enter the anti-theft code for the audio system.
- Set the clock.
- Give the new anti-theft code to the customer if you are replacing the audio unit.