Driver's Power Seat Motor Test (With DPMS)

Driver's Power Seat Motor Test

NOTE: SRS components are located in this area. Review the SRS component locations 4-door SRS Component Location Index (4-Door), 2-door SRS Component Location Index (2-Door), and precautions and procedures Service and Repair before doing repairs or servicing.

1. Remove the driver's seat Front Seat Removal/Installation.

2. Disconnect the 6P or 5Pconnector from each power seat motor.

NOTE:

- For the recline motor, remove the seat-back cover.
- 4-door Front Seat-Back Cover Replacement (4-door)
- 2-door Front Seat-Back Cover Replacement (2-door)

- The illustration shows 4-door model.










3. Test each motor by connecting power and ground according to the table. When the motor stops running, disconnect battery power immediately.





4. If the motor does not run or fails to run smoothly, replace:

- Slide motor Front Seat Slide Motor Replacement
- Front up-down motor/seat frame Front Seat Frame Replacement - Driver's Seat
- Rear up-down motor/seat frame Front Seat Frame Replacement - Driver's Seat
- Recline motor Front Seat Recline Motor Replacement

NOTE: The front and rear up-down motors are part of the seat frame.