VSA System

Control System DTCs

VSA DTC Troubleshooting: 66-11, 66-13

DTC 66-11 : Pressure Sensor Circuit Malfunction
DTC 66-13 : Pressure Sensor Malfunction

NOTE: Before you troubleshoot, record all freeze data and any on-board snapshot, and review the general troubleshooting information Reading and Clearing Diagnostic Trouble Codes.

1. Problem verification:

Problem verification
-1. Turn the ignition switch to ON (II).

-2. Clear the DTC with the HDS.

-3. Turn the ignition switch to LOCK (0), then turn it to ON (II) again.

-4. Check for DTCs with the HDS.

Is DTC 66-11 or 66-13 indicated?
-YES- The failure is duplicated. Go to step 2.
-NO- Intermittent failure, the system is OK at this time. Refer to intermittent failures troubleshooting.

2. VSA modulator-control unit check (update):

VSA modulator-control unit check (update)
-1. Turn the ignition switch to LOCK (0).

-2. Update the VSA modulator-control unit if it does not have the latest software Programming and Relearning.

-3. Turn the ignition switch to LOCK (0), then turn it to ON (II) again.

-4. Check for DTCs with the HDS.

Is DTC 66-11 or 66-13 indicated?
-YES- Check for loose terminals in the VSA modulator-control unit 22P connector. If the VSA modulator-control unit was updated and the symptom/indication is still present, replace the VSA modulator-control unit Service and Repair.
-NO- Troubleshooting is complete. If any other DTCs are indicated, go to the indicated DTCs troubleshooting.