SRS System

Control System DTCs

SRS DTC Troubleshooting: Fx-11

DTC Fx-11 ("x" can be 0 thru 9 or A thru F) : Airbags and/or Tensioners Deployment Recorded

NOTE:
* Before doing this troubleshooting procedure, find out if the vehicle was in a collision. If so, verify that all the required components were replaced with new components, of the correct part number, and that they were properly installed Service and Repair.
* Before doing this troubleshooting procedure, review SRS Precautions and Procedures Service and Repair and General Troubleshooting Information Reading and Clearing Diagnostic Trouble Codes.
* When any airbag or tensioners have deployed, go to Component Removal, Inspection, and Installation After Deployment Service and Repair.

1. DTC check:

DTC check
-1. Clear the DTCs with the HDS Reading and Clearing Diagnostic Trouble Codes.

-2. Turn the ignition switch to ON (II), then wait for 10 seconds.

-3. Check for DTCs with the HDS Reading and Clearing Diagnostic Trouble Codes.

Is DTC F1-11, F2-11, F3-11, F4-11, F5-11, or F6-11 indicated?
-DTC F1-11- Driver's airbag, left side curtain airbag, and/or driver's seat belt tensioner deployed.
-DTC F2-11- Front passenger's airbag, right side curtain airbag, and/or front passenger's seat belt tensioner deployed.
-DTC F3-11- Driver's side airbag, and/or left side curtain airbag deployed.
-DTC F4-11- Front passenger's side airbag, and/or right side curtain airbag deployed.
-DTC F5-11- Both or only one side curtain airbag and front seat belt tensioner deployed.
-DTC F6-11- Both or only one side curtain airbag and front seat belt tensioner deployed.