Front Passengers Seat Heater Test

Front Passenger's Seat Heater Test

Removal

SRS components are located in this area. Review the SRS component locations Locations and the precautions and procedures Service and Repair before doing repairs or service.

1. Battery Terminal (SRS) - Disconnection





1. Make sure the ignition switch is in LOCK (0).

2. Disconnect and isolate the negative cable and battery sensor (A) from the battery (B).

NOTE: Always disconnect the negative side first.

3. Disconnect the positive cable (C) from the battery.

4. Wait at least 3 minutes before starting work.

2. Front Seat Belt Lower Anchor Bolt - Passenger's Side





2-door

1. Remove the lower anchor bolt (A).





4-door

1. Remove the anchor cover (A).





2. Remove the lower anchor bolt (A).

3. Front Seat - Passenger's Side

2-door





4-door





1. Remove both seat track end covers (A).





2. Remove the seat mounting front bolts (A).





3. Remove the seat mounting rear bolts (A).





4. Disconnect the connectors (A).

Test

1. Seat Heater Passenger's Side - Test





1. Disconnect the connector.

2. Check for continuity between connector terminals No. 1 and No. 3 and terminals No. 2 and No. 3. There should be continuity.

3. If the continuity is not as specified, replace the seat cushion heater.

4. Connect the connector.

Installation

SRS components are located in this area. Review the SRS component locations Locations and the precautions and procedures Service and Repair before doing repairs or service.

1. Front Seat Assembly - Passenger's Side





1. Connect the connectors (A).

Front side





Rear side





2. Install the seat mounting bolts (A).

NOTE:
* Tighten the bolts by hand first, then tighten them to specified torque.
* Tighten the seat mounting bolts to the specified torque in the sequence shown. Slide the seat all the way back and tighten 1 and 2, then slide it forward and tighten 3 and 4.

2-door





4-door





3. Install both seat track end covers (A).

2. Front Seat Belt Lower Anchor Bolt - Passenger's Side





2-door

1. Assemble the washer, the collar, and the bushing on the lower anchor bolt as shown.

NOTE: Apply medium strength liquid thread lock to the lower anchor bolt before reinstallation.





2. Install the lower anchor bolt (A).





4-door

1. Install the lower anchor bolt (A).





2. Install the anchor cover (A).

3. Battery Terminal (SRS) - Reconnection





NOTE: If the battery performs abnormally, test the battery.

1. Clean the battery terminals.

2. Connect the positive cable (A) to the battery (B).

NOTE: Always connect the positive side first.

3. Connect the negative cable and battery sensor (C) to the battery.

4. Apply multipurpose grease to the terminals to prevent corrosion.