Shifter M/T: Service and Repair

M/T Shift Lever Housing Removal and Installation

Removal

SRS components are located in this area. Review the SRS Component Location Index Locations and the SRS Precautions and Procedures Service and Repair before doing repair or service.

1. Shift Lever Knob





Except K24Z7 engine

1. Lower the shift lever boot (A) to release the hooks from the boot.

2. Remove the shift lever knob (B).





K24Z7 engine

1. Lower the shift lever boot (A) to release the hooks from the boot.

2. Loosen the shift lever boot ring (B).

3. Remove the shift lever knob (C).

4. Remove the shift lever boot ring.

2. Center Console Panel





1. Remove the center console panel (A).

3. Cup Holder Panel Assembly





1. Remove the cup holder panel assembly (A).

4. Center Console





1. Remove the bolts (A).

2. Disconnect the connector (B).





3. Remove the console box mat (A).

4. Remove the bolts (B).





5. Disconnect the connector (A).





6. Remove the center console (A).

5. M/T Shift Lever Assembly





1. Remove the harness clamp (A).





2. Remove the lock pin (A).

3. Remove the washer (B).





4. Remove the clamp (A).

5. Disconnect the shift cable (B) from the shift lever (C).





6. Remove the bracket (A).





7. Remove the bolts (A).





8. Unlock the retainer lock (A).

9. Rotate the socket holder retainer (B) counterclockwise (C) until it stops, and push the retainer lock (D) into the socket holder retainer to lock the retainer.

10. Slide the socket holder (E) and the shift cable (F) out of the shift cable bracket (G).

NOTE: Do not remove the shift cable by pulling the shift cable guide (H).

Installation

SRS components are located in this area. Review the SRS Component Location Index Locations and the SRS Precautions and Procedures Service and Repair before doing repair or service.

1. M/T Shift Lever Assembly









1. Align the socket holder (A) on the shift cables (B) with the slot in the bracket base (C).

2. Slide the socket holder into the bracket base.

3. Install the shift cable ends (D) to the shift lever assembly (E).

NOTE: When installing the shift cable (shift lever side), position the serrated side (F) facing up.





4. Install the shift lever assembly (A).





5. Install the bracket (A).





6. Install the washer (A).

7. Install the lock pin (B).





8. Install the harness clamp (A).

2. Center Console





1. Install the center console (A).





2. Connect the connector (A).





3. Install the bolts (A).

4. Install the console box mat (B).





5. Connect the connector (A).

6. Install the bolts (B).

3. Cup Holder Panel Assembly





1. Install the cup holder panel assembly (A).

4. Center Console Panel





1. Install the center console panel (A).

5. Shift Lever Knob





Except K24Z7 engine

1. Install the shift lever knob (A).

NOTE: Tighten the shift lever knob until the shift pattern is properly aligned.

2. Connect the shift lever boot (B).





K24Z7 engine

1. Install and turn the shift lever boot ring (A) until it reaches the bottom of the threads on the shift lever.

2. Turn the shift lever knob (B) until the shift lever knob contacts the shift lever boot ring.

3. Tighten the shift lever boot ring and the shift lever knob together with the shift pattern properly aligned.

4. Connect the shift lever boot (C).