Transmission Mount: Service and Repair

Transmission Mount Removal and Installation

Removal

1. Upper Torque Rod Mounting Bolt - Loosen





1. Loosen the upper torque rod mounting bolt (A).

2. Air Cleaner Assembly





1. Disconnect the intake air duct (A) and the intake air pipe (B).

2. Remove the harness clamp (C).

3. Remove the air cleaner (D).

3. ECM Assembly





1. Remove the cover (A).





2. Disconnect ECM connectors A, B, and C.

NOTE: ECM connectors A, B, and C have symbols (A=(square), B=(triangle), C=(circle)) embossed on them for identification.

3. Remove the ECM (D).

4. Vehicle Lift

1. Raise the vehicle on a lift, and make sure it is securely supported.

5. Lower Torque Rod Mounting Bolt - Loosen





1. Loosen the lower torque rod mounting bolt (A).

6. Engine Jack Support (State Of A Low Vehicle)

1. Lift and support the engine with a jack and a wood block under the oil pan.

7. Transmission Mount





1. Remove the transmission mount assembly and the ground cable.

Installation

1. Transmission Mount





1. Install the transmission mount (A), and tighten the new transmission mount mounting bolts (B) and loosely install the new transmission mount bracket mounting bolts and nut (C).

2. Tighten the transmission mount mounting bolts.

3. Install the ground cable.

2. Engine Jack Support (State Of A Low Vehicle)

1. Remove the jack and the wood block.

3. Transmission Mount - Tighten





1. Tighten the transmission mount bracket mounting bolt and nuts.

4. Lower Torque Rod Mounting Bolt - Tighten





1. Loosen the lower torque mount mounting bolt.

2. Tighten the lower torque rod mount mounting bolts in the numbered sequence shown.

5. Upper Torque Rod - Tighten





1. Tighten the upper torque rod mounting bolt.

6. ECM Assembly





1. Connect ECM connectors A, B, and C.

NOTE: ECM connectors A, B, and C have symbols (A=(square), B=(triangle), C=(circle)) embossed on them for identification.

2. Install the ECM (D).





3. Install the cover (A).

7. Air Cleaner Assembly





1. Install the air cleaner (A).

2. Install the harness clamp (B).

3. Connect the intake air pipe (C) and the intake air duct (D).