Speaker Test/Replacement

Speaker Test/Replacement

Door Speaker

1. Remove the door panel:

- Front Front Door Panel Removal / Installation
- Rear Rear Door Panel Removal / Installation

2. Remove the bolt (A). Then lift the speaker (B) straight up to release the lower clips (C).

NOTICE
If you pull the speaker out too far from the door, you will damage the lower clips.





3. Disconnect the connector (D), and remove the speaker.

4. Measure the resistance between the terminals No. 1 and No. 2. There should be about 4 Ohms.

5. If the resistance is not as specified, replace the door speaker.

Door Tweeter

1. Detach the clip (A), and remove the tweeter cover (B). Then disconnect the connector (C).






2. Remove the front door tweeter (A) from the tweeter cover (B).






3. Measure the resistance between the tweeter (A) terminals as shown.

- With premium audio: Measure the resistance between the tweeter 2P connector terminals No. 1 and No. 2. There should be about 3.3 Ohms.
- Without premium audio: Measure the resistance between terminal No. 1 and the outside terminal of the capacitor (B). There should be about 4 Ohms. Also check the capacitor condition. If any problem is found, replace the tweeter.

With premium audio





Without premium audio






Subwoofer

1. Remove the passenger's rear side trim panel Interior Trim Removal / Installation - Rear Side Area.

2. Remove the bolts (A) from the subwoofer (B).





3. Detach the clips (C) and disconnect the connector (D), then remove the subwoofer.

4. Measure the resistance between the terminals No. 1 and No. 2. There should be about 2.4 Ohms.

5. If the resistance is not as specified, replace the subwoofer.