Dashboard Center Lower Cover Removal / Installation

Dashboard Center Lower Cover Removal/Installation

Special Tools Required

- KTC Trim Tool Set SOJATP2014
*

SRS components are located in this area. Review the SRS component locations Locations and the precautions and procedures Service Precautions before doing repairs or service.

NOTE:

- Take care not to scratch the dashboard or the related parts.
- Use the appropriate tool from the KTC trim tool set to avoid damage when removing components.
- When prying with a flat-tip screwdriver, wrap it with protective tape to prevent damage.

1. Remove the center console panel Center Console Panel Removal / Installation.

2. Release both front areas of the center console (A) from the dashboard.

1. Remove the screws.

2. Pull out both front bottom edges of the console to detach the clips.

3. Gently pull up both front areas of the console to release the hooks (B) from the dashboard.





3. Remove the driver's dashboard center lower cover (A).

1. Detach the clip (B).

2. Gently pull out the rear upper edge of the cover to detach the clip (C).

3. Pull up the rear area of the cover to release the hook (D) from the rear heater duct (E).

4. Pull the cover rearward to release the hook (F) from the heater unit (G).





4. Remove the passenger's dashboard center lower cover (A).

1. Detach the clip (B).

2. Gently pull out the front upper edge of the cover to detach the clip (C).

3. Pull up the cover to release the hook (D) from the rear heater duct (E).





5. Install the cover in the reverse order of removal, and note these items:

- If the clips are damaged or stress-whitened, replace them with new ones.
- Push the clips and the hooks into place securely.