Front Passenger's Power Seat Motor Test

Front Passenger's Power Seat Motor Test

NOTE: SRS components are located in this area. Review the SRS component locations Locations, and precautions and procedures Service Precautions before doing repairs or servicing.

1. Remove the front passenger's seat.

2. Remove the power seat adjustment switch knobs and the recline cover from the seat.

3. Disconnect the 12P connector (A) from the power seat adjustment switch (B).






4. At the 12P connector of the front passenger's seat wire harness side, test the motor by applying battery power and ground to the terminals according to the table.

Slide motor





Recline motor





5. If the motor does not run or fails to run smoothly, go to step 6.

6. Disconnect the 6P or 2P connector from each motor.

NOTE:

- For recline motor, remove the seat-back cover Service and Repair.
- All connector views are wire side of female terminals.









7. Check for continuity between the motor 6P or 2P connector and the front passenger's seat wire harness 12P connector. If there is continuity, replace the appropriate motor:

- Slide motor
- Recline motor