Diesel Data: Automotive Repair

Display Does Not Dim Or Brighten With Dimmer (Without Navigation)




Audio System Symptom Troubleshooting - Display does not dim or brighten with dimmer

Display does not dim or brighten with dimmer (without navigation)

NOTE:

- Check the vehicle battery condition first Battery Test.
- Check the connectors for poor connections or loose terminals.
- If the vehicle is equipped with navigation, refer to Display day/night mode does not work or does not work properly Symptom Troubleshooting.

1. Turn the ignition switch to ON (II).

2. Turn the combination light switch on and off to see if the symptom can be duplicated.

Can the symptom be duplicated?

YES -

Go to step 3.

NO -

Operation is normal at this time.

3. Turn the combination light switch off.

4. Operate the illumination control dial.

Does it operate normally?

YES -

Operation is normal at this time.

NO -

Go to step 5.

5. Turn the ignition switch to LOCK (0).

6. Disconnect and check audio unit connector A (24P) for a loose or a poor connection.

NOTE: Eject all the audio disc before removing the audio unit and audio disc changer to prevent damaging the audio disc player's loading mechanism.

7. Reconnect audio unit connector A (24P), and recheck the symptom.

Does the display dim normally?

YES -

Go to step 8.

NO -

Operation is normal at this time.

8. Turn the ignition switch to ON (II).

9. Measure the voltage between audio unit connector A (24P) terminal No. 13 and body ground.





Is there battery voltage?

YES -

Go to step 10.

NO -

Check the No. 29 (10 A) fuse in the under-dash fuse/relay box. If the fuse is OK, repair an open in the wire between the fuse and audio unit connector A (24P).

10. Measure the voltage between audio unit connector A (24P) terminals No. 13 and No. 1. Operate the dash light brightness controller dial to see if the voltage changes.





Does the voltage change?

YES -

Substitute a known-good audio unit Audio Unit Removal/Installation, and recheck. If the symptom/indication goes away, replace the original audio unit Audio Unit Removal/Installation.

NO -

There is an open in the wire between the under-dash fuse/relay box and the gauge control module.