Dashboard Center Lower Trim Removal/Installation

Dashboard Center Lower Trim Removal/Installation

Special Tools Required

- KTC Trim Tool Set SOJATP2014
*

NOTE:

- Take care not to scratch the dashboard or its related parts.
- Use the appropriate tool from the KTC trim tool set to avoid damage when removing components.

1. Remove the dashboard center lower cover Dashboard Center Lower Cover Removal/Installation.

2. Remove the dashboard center lower trim (A).

1. Pry between the dashboard (B) and the upper side of the dashboard center lower trim with the appropriate trim tool. Pry out the trim to release the clips and the hooks (C).

2. Pull out the dashboard center lower trim slightly toward you, and disconnect the accessory power socket connector (D) and the auxiliary jack connector (E) (if equipped).





3. Install the trim in the reverse order of removal, and note these items:

- If the clips are damaged or stress-whitened, replace them with new ones.
- Push the clips and the hooks into place securely.
- Make sure the connectors are plugged in properly.