C0713
DTC C0713
CIRCUIT DESCRIPTION
The Air Suspension Compressor has a temperature sensor. The Air Suspension Module monitors the temperature sensor for a compressor overtemperature condition. On receipt of a compressor overtemperature condition the air suspension module switches off the compressor relay. The relay cannot be switched on again until at least three minutes after removal of the over temperature condition.
CONDITIONS FOR RUNNING THE DTC
Ignition on.
CONDITIONS FOR SETTING THE DTC
Air Suspension Module senses a compressor overtemperature condition.
A loss of ground signal at Air Suspension moudule pin 18
ACTION TAKEN WHEN THE DTC SETS
^ Air Suspension functionality is suspended.
^ SERVICE AIR SUSPENSION message is displayed.
CONDITIONS FOR CLEARING THE DTC
The DTC will clear when the condition for setting the DTC is removed.
DIAGNOSTIC AIDS
^ This DTC is set when the compressor has run so long that it has overheated.
^ The compressor has overheated because of a blockage in the air system.
^ Bad compressor motor ground will set this DTC
TEST DESCRIPTION
The numbers below refer to the step numbers on the diagnostic table.
3. Tests whether the condition is module, system, or condition related.
4. Tests if the condition has been corrected or identified as specified in the supporting text.
6. Tests if the DTC sets during normal operating conditions.
