Center Mounted Brake Lamp: Service and Repair

HIGH MOUNTED STOP LAMP REPLACEMENT

REMOVAL PROCEDURE




1. Remove the liftgate trim panel.
2. Disconnect the electrical connector from the high mounted stop lamp.
3. Remove the retaining screws.
4. Remove the grommet from the liftgate.
5. Remove the lamp, with the attached harness, from the vehicle.

INSTALLATION PROCEDURE




1. Install the lamp, with the attached harness, to the vehicle.
2. Install the grommet to the liftgate.

NOTE: Refer to Fastener Notice in Service Precautions.

3. Install the retaining screws.

Tighten
Tighten the screws to 3 N.m (26 lb in).

4. Connect the electrical connector to the high mounted stop lamp.
5. Install the liftgate trim panel.