Identification Lamp Replacement (SUT Rear Header)

IDENTIFICATION LAMP REPLACEMENT (SUT REAR HEADER)

REMOVAL PROCEDURE
1. Protect the painted surface with 2 layers of masking tape.
2. Insert a flat-bladed tool underneath the lamp on the outer edge in order to disengage the retention clip.
3. Tilt the lamp rearward in order to disengage the lamp from the rear roof header.
4. Disconnect the electrical connector.
5. Remove the lamp from the rear roof header.
6. Turn the bulb socket counterclockwise in order to remove the socket from the lamp assembly.
7. Remove the bulb from the socket, if needed.

INSTALLATION PROCEDURE
1. Install the bulb into the socket.
2. Rotate the bulb socket clockwise into the lamp housing in order to secure.
3. Connect the electrical connector to the socket.
4. Position the lamp to the rear header opening.
5. Ensure the foam gasket is not damaged and is in place.
6. With light pressure, push downward on the lamp in order to secure the retention clip into the rear roof header.
7. Remove the 2 layers of masking tape.