Tie Rod Replacement - Inner

TIE ROD REPLACEMENT - INNER

TOOLS REQUIRED
J 34028 Inner Tie Rod Wrench

REMOVAL PROCEDURE




1. Raise the vehicle. Refer to Lifting Lifting.
2. Remove the engine protection shield.
3. Remove the outer tie rod ends.
4. Remove the inner tie rod ends using the J 34028.

INSTALLATION PROCEDURE

IMPORTANT: Perform the following procedure before installing the new tie rod ends.
- Remove all traces of the oil, grease, or other contaminants.
- Clean the threads of the tie rod with denatured alcohol or the equivalent and allow to dry.
- Apply Threadlocker GM P/N 12345493 or Canadian P/N 10953488 to the threads of the tie rod.

NOTE: Refer to Fastener Notice in Service Precautions.




1. Install the inner tie rod to the relay rod.

Tighten
Using the J 34028 tighten the tie rod to 100 N.m (74 lb ft).

2. Install the outer tie rod assemblies.
3. Install the engine protection shield.
4. Lower the vehicle.
5. Verify the wheel alignment.