Compressor Automatic Level Control Replacement (Single Compressor)

Compressor Automatic Level Control Replacement (Single Compressor)

Removal Procedure

Caution: Do NOT remove an air supply pipe in an attempt to depressurize the air suspension. Always follow the Air Suspension Depressurization Procedure. Failure to follow this procedure may cause personal injury or damage to the vehicle.

1. Remove the compressor assembly from the vehicle and place on a bench.





2. Disconnect all electrical connections (2, 3).
3. Remove the connector (3) from the mounting bracket.
4. Remove the mounting nuts (1).
5. Remove the compressor.

Installation Procedure





1. Install the compressor.

2. Notice: Refer to Fastener Notice in Service Precautions.

Install the mounting nuts (1).
^ Tighten the nuts to 25 Nm (18 ft. lbs.).
3. Install the connector (3) to the mounting bracket.
4. Connect all electrical connections (2, 3).
5. Install the compressor assembly to the vehicle.