Rear Door Window Regulator: Service and Repair

Module Replacement - Rear Power Window

Removal Procedure

1. Remove the trim panel. Refer to Trim Panel Replacement - Side Rear Door (Rear Side Door Trim Panel Replacement) .
2. Remove the water deflector. Refer to Water Deflector Replacement - Rear Door (Rear Side Door Water Deflector Replacement) .
3. Position the window in a position that allows access to the window clamp bolts.




4. Disconnect the window motor electrical connector.
5. Position the window in the full up position and tape in place.
6. Slightly loosen the fasteners on the window clamps.
7. Remove the 5 fasteners (1) retaining the window module to the door.
8. Remove the window module from the door.



Installation Procedure





1. Place the window module in position in the door.

Notice: Refer to Fastener Notice in Cautions and Notices.

2. Install the 5 fasteners (1) to the window regulator.

Tighten the fasteners to 9 Nm (7 lb ft).

3. Place the window in the window clamps, and tighten the clamps.

Tighten the clamps to 9 Nm (7 lb ft).

4. Connect the window motor electrical connector.
5. Operate the window module to inspect for proper operation.
6. Install the water deflector. Refer to Water Deflector Replacement - Front Door (Front Side Door Water Deflector Replacement) .
7. Install trim panel. Refer to Trim Panel Replacement - Side Front Door (Front Side Door Trim Panel Replacement) .