Power Brake Booster Inlet Hose Replacement

POWER BRAKE BOOSTER INLET HOSE REPLACEMENT

REMOVAL PROCEDURE

NOTE: Refer to Power Steering Hose Disconnected Notice in Service Precautions.




1. Install a drain pan under the vehicle.
2. Remove the brake booster inlet hose from the brake booster.




3. Remove the brake booster inlet hose (2) from the power steering pump.
4. Remove the brake booster inlet hose from the vehicle.

INSTALLATION PROCEDURE

NOTE:
- The inlet and outlet hoses must not be twisted during installation. Do not bend or distort the inlet or outlet hoses to make installation easier. Failure to follow these procedures could result in component damage.
- Refer to Installing Hoses Without Twists or Bends Notice in Service Precautions.




1. Route the hose in the same position the hose occupied prior to removal.
2. Install the brake booster inlet hose to the brake booster.

NOTE: Refer to Fastener Notice in Service Precautions.




3. Install the brake booster inlet hose (2) to the power steering pump.

Tighten
Tighten the brake booster inlet hose fittings to 28 N.m (21 lb.ft).

4. Remove the drain pan from under the vehicle.
5. Bleed the power steering system.