Power Steering Gear Inlet Hose

POWER STEERING GEAR INLET HOSE REPLACEMENT

REMOVAL PROCEDURE

NOTE: Refer to Power Steering Hose Disconnected Notice in Service Precautions.




1. Install a drain pan under the vehicle.
2. Remove the power steering gear inlet hose from the brake booster.




3. Remove the power steering gear inlet hose from the power steering gear.
4. Remove the power steering gear inlet hose from the vehicle.

INSTALLATION PROCEDURE

NOTE: Refer to Installing Hoses Without Twists or Bends Notice in Service Precautions.




1. Route the hose in the same position the hose occupied prior to removal.
2. Install the power steering gear inlet hose (1) to the brake booster (2).

NOTE: Refer to Fastener Notice in Service Precautions.




3. Install the power steering gear inlet hose to the power steering gear.

Tighten
Tighten the power steering gear inlet hose fittings to 28 N.m (21 lb ft).

4. Remove the drain pan from under the vehicle.
5. Bleed the power steering system.