Clutch Slave Cylinder: Service and Repair

Clutch Actuator Cylinder Replacement

Removal Procedure
1. Remove the transmission.





2. Remove the 2 clutch actuator cylinder bolts (3).
3. Remove the clutch actuator cylinder (1) from the input shaft bearing retainer (2).

Installation Procedure





1. Position the clutch actuator cylinder (1) to the input shaft bearing retainer (2).

Notice: Refer to Fastener Notice in Service Precautions.

2. Install the 2 clutch actuator cylinder bolts (3).
^ Tighten the clutch actuator cylinder bolts to 8 Nm (71 inch lbs.).
3. Install the transmission.