Transfer Case Output Shaft Seal Replacement - Rear

Transfer Case Output Shaft Seal Replacement - Rear

Tools Required

J 45756 Rear Output Shaft Seal Installer

Removal Procedure




1. Raise and suitably support the vehicle. Refer to Vehicle Lifting.
2. Remove the rear propeller shaft.
3. Remove the rear output shaft seal by prying it out with a flat-tipped screwdriver.

Installation Procedure




1. Using J 45756, install a NEW front output shaft seal.
2. Install the rear propeller shaft.
3. Check the fluid level. Add fluid, if necessary.
4. Lower the vehicle.