Cable Replacement, A/T

SPEEDOMETER CABLE REPLACEMENT





1. Correctly insert the adapter into the instrument panel, and fasten the new speedometer cable.

CAUTION:
The cable arrangement should be so that the radius of the cable bends is 150 mm (5.9 inch) or more.





2. Install the grommet as shown in the illustration so that the cable attachment part and the projection part are horizontal.
3. At the transaxle end of the speedometer cable, the key joint should be inserted into the transaxle, and the nut should be securely tightened.





CAUTION:
If the cable is not correctly and securely connected, it may cause an incorrect reading on the speedometer, or abnormal noise. Be sure to connect it correctly.


Closed Throttle Position Switch Check and Adjustment

1. After warming up the engine, make sure that the closed throttle position switch is on with the accelerator pedal in the free state.

NOTE:
Check to see that the closed throttle position switch is on or off by checking the voltage between the wire at the closed throttle position switch connector and the ground wire.
- When the closed throttle position switch is ON: 0V
- When the closed throttle position switch is OFF: 12V