With Generic Scan Tool

MALFUNCTION INDICATOR LAMP (MIL) INSPECTION
1. After turning on (ON position) the ignition key, check that the light illuminates continuously without the engine running.
2. If the light does not illuminate continuously without the engine running, check for an open circuit in harness, blown fuse or blown bulb




INSPECTION PROCEDURE (USING GST)
1. Turn OFF the ignition switch.
2. Connect the GST to the data link connector located below steering wheel.
3. Turn ON the ignition switch.
4. Use the GST to check the diagnostic trouble code.
5. Repair the faulty part from the diagnosis chart.
6. Erase the diagnostic trouble code.
7. Disconnect the GST.

NOTE:
(1) When battery voltage is low, diagnostic trouble codes can not be read. Be sure to check the battery for voltage and other conditions before starting the test.
(2) Diagnosis memory is erased if the battery or the ECM connector is disconnected. Do not disconnect the battery before the diagnostic trouble codes are completely read and recorded.