III. Special Instruct. For '96 - Pres. Elantra/Tiburon/Accent

III. Special Instructions For 1996 - Present Elantra/Tiburon & All Accent:

1. Remove the glove box, and main lower dash pad assembly (on Accent, the glove box only needs to be lowered).

2. Mark the evaporator casing.

A. Draw a vertical line on the upper half of the evaporator casing that is flush with the left edge of the right side mounting bracket.

B. Measure 2 inches up from the casing joint along the vertical line made in step A.

C. Mark a spot to locate the hole to be drilled.

3. Using a 7 mm drill bit, drill a hole shallow enough to just pierce through the evaporator casing at the location marked from step 2.

CAUTION:
Drill only deep enough to pierce the evaporator case.

4. Go to "Cleaning Instructions: All Models" section in this TSB.